Akw Itherm - Setting Cold Water Flush Mode

6
© 2015 AKW 14-019-002-08
User
User Operating Instructions
6
User Operating Instructions
*
Press the power button
Turn the
Temperature
control knob
clockwise until
the temperature
display is shown
like the
illustration
Turn the Temperature
control knob 180°
anti-clockwise and the
shower will enter cold
flow (no heating)
To adjust the
shower back to
30°C, turn the
Temperature
Control knob by
two clicks (NOT
180°).
*Inlet water temperature will vary dependent on season and location
Cold Water Setting
Turn on power at
pull cord/switch.
Step 1 Step 2
Step 3 Step 4
180˚