Akw Itherm - User Volume Setting; Audible Tone Configuration

7
© 2015 AKW 14-019-002-08
© 2015 AKW 13-012-085-13
User
User Volume Setting
6
User Volume Setting
Step 1
Step 2
Step 3
Press and hold
Temp ‘+’ and Flow ‘+’
simultaneously for
3 seconds to enter
Volume Set Mode
Mute Min. Max.Default
Press Temp ‘-‘ to
save the settings. The
shower will revert to
Standby mode when
complete.
Adjust Volume Level
Exit Volume Setting
Enter Volume Setting
The iTherm Electric Shower has audible tones enabled in its factory
settings. This can be enabled/disabled for your preference. Please
contact a qualified local installer and refer them to Page 29 to change
it to your preference.
When enabled , audible tones occur in the following state:
• Single beep when switched on
• 2 beeps when Temp/Flow are at the end of their adjustment range
• Multiple (approx. 8) when in phased shut-down
• Multiple beeps for 30 seconds after the shower has been running
for 30 minutes