3 | ADC-V622 180° Camera with Digital Pan / Tilt / Zoom Quick Installation Guide | 4
You can now power down the camera and install it in its
final location using the included hardware.
AP MODE
1 Connect the camera’s AC power adapter and plug it into
a non-switched outlet.
2 Press the Menu button and use the Volume buttons to scroll
to the Access Point Mode (follow the audio prompts or look
3 Press the Menu button to activate Access Point Mode.
4 On an Internet enabled device, connect to the Wi-Fi network
of the ADC-V622’s MAC address, which is located on the back
of the device near the power cord.
5 On the same device, open a web browser and enter
instructions to add the ADC-V622 to the Wi-Fi network.
The LED will be solid green when the connection is complete.
6 Add the device to the account by either selecting the account
in MobileTech OR by using a web browser and entering the
7 Select the camera from the video device list or type in its
MAC address to begin adding the camera. The camera’s
MAC address is located on the back of the camera near
the power cable.
8
Customer Website.
You can now power down the camera and install it in its
final location using the included hardware.
WPS MODE
1 Connect the camera’s AC power adapter and plug it into
a non-switched outlet.
2 Press the Menu button and use the Volume buttons to scroll
to the WPS menu option (follow the audio prompts or look
3 Press the Menu button to activate WPS Mode.
To Next Page
Loading...
Need help?
General
