EasyManuals Logo

Alarm.Com ADC-V622 Quick Installation Guide

Alarm.Com ADC-V622
9 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
9 | ADC-V622 180° Camera with Digital Pan / Tilt / Zoom Quick Installation Guide | 10
Troubleshooting
1 If you have issues connecting the camera to the account,
power cycle the camera. If using the AC adapter, unplug
the power jack from the camera and then plug it back in
to restore power. If using PoE, unplug the Ethernet jack
from the camera and then plug it back in to restore power.
2 If issues persist, try resetting the camera to factory defaults.
Press the Menu button and use the Volume buttons to scroll
to the Factory Reset option. Follow the audio prompts to
initiate Factory Reset. The camera will reboot with factory
defaults. If the camera was previously installed on an
Alarm.com account, it will need to be deleted before it
can be installed again.
QUESTIONS?

FEDERAL COMMUNICATION COMMISSION
INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television


Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.

connected.


for compliance could void the user’s authority to operate this equipment.

(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna
or transmitter.
For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other
channels is not possible.
This device is restricted to indoor use.

Other manuals for Alarm.Com ADC-V622

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alarm.Com ADC-V622 and is the answer not in the manual?

Alarm.Com ADC-V622 Specifications

General IconGeneral
BrandAlarm.Com
ModelADC-V622
CategoryDigital Camera
LanguageEnglish

Related product manuals