System Management
7450 ESS OS Basic System Configuration Guide Page 355
count
Syntax count number
Context config>cron>sched
Description This command configures the total number of times a CRON “interval” schedule is run. For example, if the
interval is set to 600 and the count is set to 4, the schedule runs 4 times at 600 second intervals.
Parameters number — The number of times the schedule is run.
Values 1 — 65535
Default 65535
day-of-month
Syntax [no] day-of-month {day-number [..day-number] all}
Context config>cron>sched
Description This command specifies which days of the month that the schedule will occur. Multiple days of the month
can be specified. When multiple days are configured, each of them will cause the schedule to trigger. If a
day-of-month is configured without configuring month, weekday, hour and minute, the event will not
execute.
Using the weekday command as well as the day-of-month command will cause the script to run twice. For
example, consider that “today” is Monday January 1. If “Tuesday January 5” is configured, the script will
run on Tuesday (tomorrow) as well as January 5 (Friday).
The no form of this command removes the specified day-of-month from the list.
Parameters day-number — The positive integers specify the day of the month counting from the first of the month. The
negative integers specify the day of the month counting from the last day of the month. For example,
configuring day-of-month -5, 5 in a month that has 31 days will specify the schedule to occur on the
27th and 5th of that month.
Integer values must map to a valid day for the month in question. For example, February 30 is not a
valid date.
Values 1 — 31, -31 — -1 (maximum 62 day-numbers)
all — Specifies all days of the month.
To Next Page
Loading...
