Installing MDAs
Page 106 7450 ESS-7
To install an MDA:
Step 1 Install the IOM first. See Installing IOMs on page 99.
Step 2 Remove the MDA from the packaging. Avoid touching board components and connector
pins.
Step 3 Insert the MDA into the slot. Align the MDA with the slot guides and the captive screw
with the threaded receptacle.
Step 4 Tighten the captive screws to secure the MDA. Do not over-tighten. The maximum
recommended torque is 10 lbf.in.
Step 5 Check the Power LED on the MDA faceplate.
Step 6 Attach cables to the MDA ports.
To Next Page
Loading...
