Field Replaceable Units
7450 ESS-7 Page 131
REPLACING AN SF/CPM
NOTE: Each SF/CPM module has two ejector levers which seats and releases the card from the
backplane connectors. During installation, the ejector levers must be positioned inward and then
rotated outward to lock into place. The ejector levers must remain in the locked position while the
card is installed in the chassis.
Figure 46: Installing the SF/CPM Module
Table 40: Installing SF/CPM Features
Key Description
1 Slot guide
2 SF/CPM positioned in the slot guide
3 SF/CPM captive screw (2 per SF/CPM)
4 Ejector lever
To Next Page
Loading...
