Field Replaceable Units
7450 ESS-7 Page 141
CHANGING THE MDA CONFIGURATION
If you replace an MDA with a different type, you must change the configuration to reflect the new
MDA type prior to the installation. Each active port must be shut down in order to shut down and
remove an MDA configuration. Refer to the Alcatel-Lucent OS System Guide for details on
configuring cards, MDAs, and ports.
Issue the following commands in the
config context to shut down ports and remove the MDA
from the configuration:
Command Example
Step 1 port port-id* port 5/1/1
Step 2 shutdown shutdown
*NOTE: The port>shutdown command must be entered for all enabled ports on the MDA.
Step 3 exit exit
Step 4 card slot-number card 5
Step 5 mda mda-slot mda 1
Step 6 shutdown shutdown
Step 7 exit exit
Step 8 no mda mda-slot no mda 1
Step 9 card slot-number card 5
Step 10 card-type card-type card-type iom-20g
Step 11 shutdown shutdown
Step 12 mda mda-slot mda 1
Step 13 mda-type mda-type mda m1-10gb
Step 14 shutdown shutdown
Step 15 exit exit
To Next Page
Loading...
