Installing Power Modules
7450 ESS-7 Page 69
To prepare the cable:
Step 1 Using a wire-stripping tool, strip the insulation from the wire to 1 1/8-inches.
Step 2 Locate the lug in the accessory box or use a lug such as a Panduit LCC6-10A-L copper,
standard barrel, 2-hole lug with two .200-inch (
.508 cm) diameter holes on a .625-inch
(1.6 cm) spacing. Slide the open end of the lug over the exposed area of the prepared wire.
Step 3 Using a crimping tool, crimp the lug to the wire.
Table 22: DC Power Cable Description
Key Description
1 Copper wire
2 Insulation stripped 1 1/8-inch
To Next Page
Loading...
