Root Commands
7450 ESS OS Basic System Configuration Guide Page 119
subscriber
Syntax subscriber sub-ident-string [arbiter name | root] [ingress | egress] [interval seconds] [repeat
repeat] [absolute | rate]
Context monitor>qos>arbiter-stats
Description This command monitors arbiter statistics for a subscriber.
Parameters sub-ident-string — Specifies an existing subscriber a identification policy name.
arbiter name — Specify the name of the policer control policy arbiter.
Values An existing scheduler-name in the form of a string up to 32 characters long composed of
printable, 7-bit ASCII characters. If the string contains special characters (#, $, spaces,
etc.), the entire string must be enclosed within double quotes.
root — Specify the scheduler to which this queue would be feeding.
ingress — Displays scheduler-name statistics applied on the ingress SAP.
egress — Displays scheduler-name statistics applied on the egress SAP.
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without processing.
No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead of the
delta.
customer
Syntax customer customer-id site customer-site-name [scheduler scheduler-name] [ingress | egress]
[interval seconds] [repeat repeat] [absolute | rate]
Context monitor>qos>scheduler-stats
Description Use this command to monitor scheduler statistics per customer multi-service-site. The first screen displays
the current statistics related to the specified customer ID and customer site name. The subsequent statistical
information listed for each interval is displayed as a delta to the previous display. When the keyword rate is
specified, the "rate per second" for each statistic is displayed instead of the delta.
Monitor commands are similar to show commands but only statistical information displays. These
commands display selected statistics per the configured number of times at the interval specified.
Parameters customer-id — Specifies the ID number to be associated with the customer, expressed as an integer.
Values 1 — 2147483647
To Next Page
Loading...
