Alcatel-Lucent 7450 ESS-7 - System Management Parameters; System Information

Show Commands
Page 204 7450 ESS OS Basic System Configuration Guide
Sample Output
A:ALA-1# show bof cf3:
=====================================================================
BOF on cf3:
=====================================================================
autonegotiate
primary-image ftp://test:test@192.168.xx.xx/./both.tim
primary-config ftp://test:test@192.168.xx.xx/./1xx.cfg
secondary-image cf1:/i650/
secondary-config cf1:/config.cfg
address 192.168.xx.xxx/20 active
address 192.168.xx.xxx/20 standby
primary-dns 192.168.xx.xxx
wait
The time configured for the boot to pause while waiting for console
input.
autonegotiate
No autonegotiate — Autonegotiate not enabled.
autonegotiate — Autonegotiate is enabled.
duplex
half — Specifies that the system uses half duplex.
full — Specifies that the system uses full duplex.
speed
The speed of the CPM Ethernet interface.
console speed
The console port baud rate.
dns domain
The domain name used when performing DNS address resolution.
uplinkA-address
Displays the Uplink-A IP address.
uplinkA-port
Displays the primary port to be used for auto-boot.
uplinkA-route
Displays the static route associated with Uplink-A.
uplinkA-vlan
Displays the VLAN ID to be used on Uplink-A.
uplinkB-address
Displays the Uplink-B IP address.
uplinkB-port
Displays the secondary port to be used for auto-boot.
uplinkB-route
Displays the static route associated with Uplink-B.
uplinkB-vlan
Displays the VLAN ID to be used on Uplink-B.
uplink-mode
This parameter displays the uplink mode of the device.
no-service-ports
Displays the ports on which service traffic is not processed.
use-expansion-
card-type
Displays the expansion card type.
Table 20: Show BOF Output Fields (Continued)
Label Description