Alcatel-Lucent 7450 ESS-7 - Page 340

System Management
7450 ESS OS Basic System Configuration Guide Page 313
System Synchronization Commands
config
—system
— sync-if-timing
— abort
— begin
— bits
— input
— [no] shutdown
— interface-type {ds1 [{esf | sf}] | e1 [{pcm30crc | pcm31crc}]}
—no interface-type
— output
— line-length {110, 220, 330, 440, 550, 660}
— [no] shutdown
— source {line-ref|internal-clock}
— ql-override {prs | stu | st2 | tnc | st3e | st3 | eec1 | sec | prc | ssu-a | ssu-b | eec2}
—no ql-override
— ssm-bit sa-bit
— commit
— ref-order first second [third [fourth]]
—no ref-order
— ptp
— ql-override {prs | stu | st2 | tnc | st3e | st3 | eec1 | sec | prc | ssu-a | ssu-b | eec2}
—no ql-override
— [no] shutdown
— ref1
— ql-override {prs | stu | st2 | tnc | st3e | st3 | eec1 | sec | prc | ssu-a | ssu-b | eec2}
—no ql-override
— [no] shutdown
— source-port port-id
—no source-port
— ref2
— ql-override {prs | stu |
st2 | tnc | st3e | st3 | eec1 | sec | prc | ssu-a | ssu-b | eec2}
—no ql-override
— [no] shutdown
— source-port port-id
—no source-port
— [no] ql-selection
— [no] revert
The following commands apply to the 7450 ESS-6 and 7450 ESS-6v models.
config
—system
— sync-if-timing
— abort
— begin
— commit
— ref-order first second [third]
—no ref-order
— ref1
— ql-override {prs | stu | st2 | tnc | st3e | st3 | eec1 | sec | prc | ssu-a | ssu-b |
eec2}