Alcatel-Lucent 7450 ESS-7 - cron; profile

Page 390 7450 ESS OS Basic System Configuration Guide
Default 128
Parameters priority — Specifies the value of the priority1 field.
Values 0 — 255
priority2
Syntax [no] priority2 priority
Context config>system>ptp
This command configures the priority2 value of the local clock. This parameter is only used when the profile
is set to ieee1588-2008. This value is used by the Best Master Clock algorithm to determine which clock
should provide timing for the network.
Note: This value is used for the value to advertise in the Announce messages and for local clock value in
data set comparisons..
The no form of the command reverts to the default configuration.
Default 128
Parameters priority — Specifies the value of the priority2 field.
Values 0 — 255
profile
Syntax profile {g8265dot1-2010 | ieee1588-2008}
Context config>system>ptp
Description This command configures the profile to be used for the internal PTP clock. It defines the BMCA behavior.
The profile cannot be changed unless PTP is shutdown.
When you change the profile, the domain changes to the default value for the new profile.
Default ieee1588-2008
Parameters ieee1588-2008 — Conform to the default BMCA of the 2008 version of the IEEE1588 standard.
g.8265.1-2010 — Conform to the BMCA specified in the ITU-T G.8264.1 specification.