Page 476 7450 ESS OS Basic System Configuration Guide
*A:Dut-B# show system sync-if-timing
=======================================================================
System Interface Timing Operational Info
=======================================================================
System Status CPM A : Master Locked
Reference Input Mode : Non-revertive
Quality Level Selection : Disabled
Reference Selected : Mate CPM (BITS B)
System Quality Level : prs
Current Frequency Offset (ppm) : +0
Reference Order : bits ref1 ref2
Reference Mate CPM
Qualified For Use : Yes
Selected For Use : Yes
Reference Input 1
Admin Status : up
Rx Quality Level : prs
Quality Level Override : none
Qualified For Use : Yes
Selected For Use : No
Not Selected Due To : on standby
Source Port : 3/1/2
Reference Input 2
Admin Status : down
Rx Quality Level : unknown
Quality Level Override : none
Qualified For Use : No
Not Qualified Due To : disabled
Selected For Use : No
Not Selected Due To : disabled
Source Port : None
Reference BITS A
Admin Status : up
Rx Quality Level : unknown
Quality Level Override : none
Qualified For Use : No
Not Qualified Due To : LOS
Selected For Use : No
Not Selected Due To : not qualified
Interface Type : DS1
Framing : ESF
Line Coding : B8ZS
Line Length : 550-660ft
Output Admin Status : up
Output Admin State : ref1
Output Source : prs
Output Reference Selected : ptp
Tx Quality Level : prs
======================================================================
The following example is for a node whose standby CPM is locked to its local BITS port and the signal from
ref1 is directed to the BITS output port:
A:SR7# show system sync-if-timing standby
To Next Page
Loading...
