1. Rotate the metal foot to flat.
2. Remove the rubber cover on phone
back shell each side.
1. Drill two holes on the wall
(separation=90mm, diameter=6mm).
2. Insert the fastener into the holes on wall
(P/N: 1AD007550003).
3. Fix the support with both screws and
adjust (P/N: 1 1AD007460003). The
support is used as a reference and must
be removeable.
1. Put the support on the back side of the
phone.
2. Slide it to top side and make sure the 4
hooks hold the metal foot.
3. Attach the magnetic alphabetic keyboard
to the metal foot.
4. Push on the two corners of mini-keyboard
to fix it in the support.
1. Fix the support with the phone by 1 screw
(P/N: 1AD100020003).
2. Connect cables through the hole on
support left side or right side.
To connect ethernet, use RJ45 cable (P/N:
1AB045210162).
To connect the power, use extension cable (P/N:
1AB203010001).
1. Hang the assembled phone with support
on the wall.
To Next Page
Loading...
