Maintenance Manual –
8242 DECT Handset
8AL 90310 USAA Ed01 5 /18
2.2.2 Reset settings
This feature allows the Admin to clear only the changed parameters in Settings menu to default, without
clearing the registration. Same function as the Reset Settings in the settings menu. Please note that it
does not reset the Alarm settings, nor clear local contacts, nor calendar appointments, nor Alarm nor
ringing melody selection and volume level.
Valid inputs: Yes or No
Screenshots
2.2.3 Site Survey Mode
This feature allows the user to enable the Site Survey mode. Once Site Survey mode is enabled, it will
remain active until it is disabled or the phone is restarted.
This mode is intended for debugging purpose and shall not be used for normal end user operation (while
active, this mode can interfere with other features of the phone).
Valid inputs: On or off
Screenshots
In Site Survey Mode the handset MMI shows the RFP to which the handset is locked to and the
corresponding signal strength (RSSI).
Handsets in site survey mode can display up to 5 Bases/DAPs with the strongest signal strength.
Note: In this mode, battery autonomy is reduced.
Valid Inputs: On or Off
Legend for the site survey:
Line 1: Lock State | Frequency | Slot | Base RPN locked |
Line 2: RPN (up to 5 Bases/DAPs)
Line 3: RSSI (up to 5 Bases/DAPs)
Line 4: A field CRC error | X field CRC error | Z field CRC error | No Lock / Lock to: base number
Line 5: Quality index | Slow/Rapid Measurements | Syn error field | Fading.
To Next Page
Loading...
