Alcatel-Lucent M5 - Page 81

81/91
Accessories
8AL90382ENAA ed03
To remove the device, follow instructions described in the section: “Removing a Bluetooth
®
accessory (headset, handset, etc.)”.
7.3.7 Connect the device to the desk phone using the USB cable
• Connect the device to the USB type A connector of the desk phone using the provided USB
cable. The Konftel EGO automatically starts. The following icon is displayed on the screen of
the device: .
• The Konftel EGO is detected as a hands-free device. Select 'Konftel Ego' on the pop-up
displayed on your desk phone.
• The device is ready for use.
7.3.8 Connect the device to the desk phone using Bluetooth
®
(compatible Bluetooth
®
desk
phone)
• Switch on the Konftel EGO.
• Put the device in detectable mode: hold the Bluetooth
®
button down for two seconds on
the Konftel EGO: . The following icon is displayed on the screen of the device: .
• From your desk phone, pairing the Konftel EGO:
The phone is in idle state.
Menu Press the Menu soft key to access the Main Menu.
Basic Setting Use up-down and 'ok' navigation keys to select: Basic Setting.
Bluetooth Use up-down and 'ok' navigation keys to select: Bluetooth .
Paired Bluetooth
Device
Use up-down and 'ok' navigation keys to select: Paired Bluetooth
Device .
Scan
Press the softkey under the following label: Scan.
Scanning starts.
Select the relevant equipment: “Konftel Ego”
Connect
Add the device by pressing on the associated key: Connect .
• The Konftel EGO is successfully paired. The following icon is displayed a couple
of seconds on the Konftel EGO screen: . It is detected as a Bluetooth
®
headset. The following icons are displayed on the status bar of your desk
phone: , .
P86_9182: