Rack Mounting Power Supplies Mounting OS6400 Switches
page 3-14 OmniSwitch 6400 Series Hardware Users Guide August 2008
Rack Mounting Power Supplies
The following sections describe how to rack-mount a power supply shelf and connect the power supply
with a cable.
Note. For information on connecting a power supply directly to the rear of the chassis (without a connec-
tor cable), refer to “Connecting a Power Supply to the Chassis” on page 3-12.
Power Supply Shelf Rack Mounting Steps
Follow the steps below to rack-mount the power supply shelf:
1 Align the threaded holes in the provided rack-mount flanges with the two holes in the power supply
shelf. These holes are located on the left and right sides of the shelf.
2 Attach the flanges to the chassis using the provided Phillips-head screws. The screws slide through the
non-threaded holes from the inside of the power supply shelf and are then attached to the mounting brack-
ets using the threaded holes. Be sure to tighten each of the screws firmly using a Phillips screwdriver.
Attaching a Rack-Mount Flange
3 Carefully slide the power supply on to the power shelf and secure the power supply to the shelf using
the captive screws.
Attaching a Power Supply to the Power Shelf
Tighten these screws
to secure the power
supply.
To Next Page
Loading...
