Connecting Chassis to Power Source Mounting OS6400 Switches
page 3-18 OmniSwitch 6400 Series Hardware Users Guide August 2008
Connecting Chassis to Power Source
AC Power Supply Connections
Since the power cord is the switch’s only disconnect device, it should be plugged into an easily accessible
outlet. In the event that your power cord is lost or damaged, refer to the specifications below.
Powering On a Chassis
Follow the steps below to power on the chassis using and AC power source:
1 Connect the IEC-60320-C15 end of the supplied power cord to the primary and optional redundant
power supply.
2 Connect the country specific ends of the supplied power cord to the AC power source.
3 Monitor the chassis as it boots.
To Next Page
Loading...
