Tabletop Installation Mounting OS6400 Switches
page 3-6 OmniSwitch 6400 Series Hardware Users Guide August 2008
4 If the table mount flange kit is being used, install the table mount brackets to the rear portion of the
chassis.
5 Mount the switch assembly on the table by inserting attachment screws through the flat portion of the
mounting brackets and into the mounting surface.
Next Steps
Powering On the Switch
To power on the chassis refer to “Connecting Chassis to Power Source” on page 3-18.
Stacking Multiple Switches Into a Virtual Chassis
To stack multiple switches into a virtual chassis, refer to “Setting Up a Stacked Configuration” on
page 3-9.
To Next Page
Loading...
