Mounting OS6400 Switches Connecting a Power Supply to the Chassis
OmniSwitch 6400 Series Hardware Users Guide August 2008 page 3-13
4 Carefully slide the power supply against the back of the chassis until the power connectors securely
connect.
5 Verify that the captive screw for the power supply is aligned with the threaded hole in the power
supply shelf. Secure the power supply to the power supply shelf by tightening the captive screw.
6 Repeat the steps above for any additional required power supplies.
Next Steps
Mounting the Switch
For information on table mounting the switch and power supply tray, refer to “Tabletop Installation” on
page 3-5. For information on rack mounting the switch and power supply tray, refer to “Rack-Mount
Installation” on page 3-7.
Powering On the Switch
To power on the chassis refer to “Connecting Chassis to Power Source” on page 3-18.
Stacking Multiple Switches Into a Virtual On the Switch
To stack multiple switches into a virtual chassis, refer to “Setting Up a Stacked Configuration” on
page 3-9.
To Next Page
Loading...
