Mounting OS6400 Switches Connecting Chassis to Power Source
OmniSwitch 6400 Series Hardware Users Guide August 2008 page 3-21
4 Tighten the clamp by tightening the screw above the slot into which you inserted the wire lead. The
wire lead should be securely attached inside the connector. You should be able to pull on the wire and not
dislodge it.
Warning. The positive (+) wire of the sourcing equipment, such as a battery or rectifier, must be
connected to the positive (+) terminal of the OmniSwitch DC power supply and the negative (-) wire of
the sourcing equipment must be connected to the negative (-) terminal of the OmniSwitch DC power
supply.
5 Repeat Steps 2 through 4 for the remaining positive and negative wire leads.
Correct Polarity Connections
DC Power Source
OS6400 Power Supply
To Next Page
Loading...
