TM3Service@outlook.com
USA
877 368 8246
USA
− Only connect the shaver if the line vol-
tage of the socket corresponds to the
nameplate specification of the power
supply unit.
− Only use the shaver with the enclosed po
-
wer supply unit. The shaver requires safety
extra-low voltage (SELV) with the values
specified in the chapter “Technical data”.
− Only connect the power supply unit to an
easily accessible socket so that you can
quickly disconnect it from the grid in case
of a failure.
− If the power cord, the power supply unit
or the shaver exhibit visible damages or
are defective, do not use them further.
− If the power cord of the shaver is da
-
maged, the manufacturer, its customer
service team or a person with similar
qualifications must replace it.
− Never operate this appliance when it
has a damaged cord or plug, when it is
not working properly, after it has been
dropped or damaged, or after it has been
dropped into water. Return the appliance
to a service center for examination and
repair.
To Next Page
Loading...
