TM3Service@outlook.com
USA
877 368 8246
USA
Daily cleaning after a dry shave
1. Before cleaning, pull the 5 V plug
8
out of the
shaver (see fig.A and B).
2. Use the On/Off switch
5
to turn off the shaver.
3. Hold the shaver over the sink.
4. Depress both release buttons
4
to release the
shaver head
2
(see fig.E).
5. Pull the shaver head up and off.
6. Knock the shaver head out gently over a sink to re-
move stubbles.
7. Without the shaver head mounted, use the On/Off
switch
5
to switch the shaver on for approx. 5 – 10
seconds to dispel any stubble from the shaver blades
3
.
8. Firmly mount the shaver head on the shaver until the
locking mechanism audibly engages (see fig. F).
9. Place the protective cap
1
on the shaver.
The shaver is now ready for use again.
To Next Page
Loading...
Need help?
General
