TM3Service@outlook.com
USA
877 368 8246
USA
Weekly cleaning
It is recommended that you thoroughly clean the shav-
er once a week. To do so, proceed as follows:
1. Before cleaning, pull the 5 V plug
8
out of the
shaver (see fig. A and B).
2. Use the On/Off switch
5
to switch the shaver off
(see fig. A).
3. Hold the shaver over the sink.
4. Depress both release buttons
4
to release the
shaver head
2
(see fig.E).
5. Pull the shaver head up and off.
6. Knock the shaver head out gently over a sink to re-
move stubbles.
7. Thoroughly wash the shaver head under warm run-
ning water from the inside and outside (see fig.G).
8. Carefully dry the shaver head with a lint-free cloth or
a paper towel. In the process, do not push the shav-
ing foils in.
9. Without the shaver head mounted, use the On/Off
switch
5
to switch the shaver on for approx. 5 – 10 sec-
onds to dispel any stubble from the shaver blades
3
.
10. Switch the shaver back off.
11. Use the cleaning brush
7
to completely remove all
stubbles from the shaver blades and the entire top
part of the shaver (see fig.A and I).
12. Thoroughly rinse off the top part of the shaver and the
shaver blades under warm running water (see fig.H).
To Next Page
Loading...
Need help?
General
