TM3Service@outlook.com
USA
877 368 8246
Daily cleaning after a wet shave
1. Before cleaning, pull the 5 V plug
8
out of the
shaver (see fig.A and B).
2. Use the On/Off switch
5
to turn off the shaver.
3. Hold the shaver over the sink.
4. Depress both release buttons
4
to release the
shaver head
2
(see fig. E).
5. Pull the shaver head
2
up and off (see fig.A).
6. Wash the shaver head thoroughly under warm run-
ning water on the inside and outside (see fig.G).
7. Carefully dry the shaver head with a lint-free cloth or
a paper towel. In the process, do not push the shav-
ing foils in.
8. Thoroughly rinse off the top part of the shaver and
the shaver blades under warm running water (see
fig.H).
9. Use the On/Off switch
5
to switch the shaver on
without the shaver head for approx. 5 – 10 seconds
to dispel any drops of water off of the shaver blades
4
.
10. Use a lint-free cloth or a paper towel to thoroughly
dry off the shaver.
11. Firmly mount the shaver head on the shaver until the
locking mechanism audibly engages (see fig. F).
12. Place the protective cap
1
on the shaver.
The shaver is now ready for use again.
To Next Page
Loading...
Need help?
General
