TM3Service@outlook.com
USA
877 368 8246
USA
6. Shave as described in steps 2 – 4.
7. If necessary, use the trimmer
14
as described in the
chapter “Using the trimmer” (see fig. D).
8. Switch the shaver off once you have finished
shaving.
9. Clean the shaver as described in the chapter “Daily
cleaning after a dry shave”.
Wet shave
1. Dampen your face and apply shaving cream or gel to
your face.
2. Take the protective cap
1
off of the shaver
(see fig. A).
3. Use the On/Off switch
5
to turn the shaver on.
4. While applying gentle pressure, move the shaver
head
2
perpendicular to the direction of hair
growth.
5. After a few strokes, use your free hand to check the
results and repeat
step 4 if necessary.
6. Shave as described in steps 2 – 4.
7. If necessary, use the trimmer as described in the
chapter “Using the trimmer”.
8. Switch the shaver off once you have finished
shaving.
9. Clean the shaver as described in the chapter “Daily
cleaning after a wet shave”.
To Next Page
Loading...
Need help?
General
