TM3Service@outlook.com
USA
877 368 8246
2. Connect the AC adapter plug
10
in a properly in-
stalled socket.
The grid symbol
13
on the handle illuminates in red
to indicate that the battery is charging. The battery
symbol
12
flashes in green as soon as the rechar-
geable battery is fully charged.
3. To charge the shaver, place it on a dry and level sur-
face or shave in grid mode.
Handling
Dry shave
NOTICE!
We recommend a dry shave before you
wash. After washing, you skin is slightly
swollen. As a result, shavers are often un-
able to reach the entire length of your beard
hair so the shave will be less thorough.
For a dry shave, follow the steps below:
1. Take the protective cap
1
off of the shaver
(see fig. A).
2. Use the On/Off switch
5
to turn the shaver on.
3. Use your free hand to stretch the part of your face
you intend to shave.
4. Apply gentle pressure to move the shaver head
2
perpendicular to the direction of hair growth.
5. After a few strokes, use your free hand to check the
results and repeat step 4 if necessary.
To Next Page
Loading...
Need help?
General
