ALDI FERREX 704518 - Additional Saw Safety Rules

MODEL No.: PSC1856.A, PRODUCT No.: 704518
9
b) Check the operation of the lower guard spring. If the guard and the
spring are not operating properly, they must be serviced before use.
Lower guard may operate sluggishly due to damaged parts, gummy
deposits, or a build-up of debris.
c) The lower guard may be retracted manually only for special cuts such as
"plunge cuts" and "compound cuts." Raise the lower guard by retracting
handle and as soon as the blade enters the material, the lower guard
must be released. For all other sawing, the lower guard should operate
automatically.
d) Always observe that the lower guard is covering the blade before
placing the saw down on bench or oor. An unprotected, coasting blade
will cause the saw to walk backwards, cutting whatever is in its path. Be
aware of the time it takes for the blade to stop after switch is released.
ADDITIONAL SAFETY RULES FOR YOUR CIRCULAR SAW
1. Only use saw blades recommended in the specication.
2. Do not use any abrasive wheels.
3. Use only blade diameter(s) in accordance with the markings.
4. Identify the correct saw blade to be used for the material to be cut.
5. Use only saw blades that are marked with a speed equal or higher than the
speed marked on the tool.