12
1200W Circular Saw
AFTER SALES SUPPORT
(toll free)
e-mail: info.aldi@positecgroup.com
1300 889 028
MODEL No.: PSC1856.A • 02/2021 • 704518
Assembly
WARNING: Ensure the product is disconnected from the mains
power supply before attempting any assembly.
Attaching the dust extraction adapter
Fasten the dust extraction adapter (23) onto the dust
extraction outlet (11) until it latches. Directly connect
a suitable vacuum hose to the adapter.
(Fig. A)
NOTE: The dust extraction adapter (23) must not
be mounted when no external dust extraction
is connected. Otherwise there is danger of the
extraction system becoming clogged.
Clean the dust extraction adapter (23) regularly
to ensure optimum dust extraction. The vacuum
cleaner must be suitable for the material to be worked.
Attaching the parallel guide
The parallel guide is used for making cuts parallel to a workpiece edge at a
chosen distance. First turn the parallel guide lock knob (4) anti-clockwise to
loosen (Fig. B1), then slide the parallel guide (5) arm through the xture to
achieve the required cutting distance (Fig. B2), then tighten the parallel guide
lock knob (4) by turning it clockwise to securely clamp the parallel guide (5) (Fig.
B3).
NOTE:
It is best to carry out a trial cut before cutting your workpiece.
B1
B2
B3
A
To Next Page
Loading...
Need help?
General
