ALDI FERREX 704518 - Making a Pocket Cut

16
1200W Circular Saw
AFTER SALES SUPPORT
(toll free)
e-mail: info.aldi@positecgroup.com
1300 889 028
MODEL No.: PSC1856.A • 02/2021 • 704518
NOTE: Do not remove the saw from the work piece while the blade is
moving.
NOTE: Since blade thickness varies, always make a trial cut in scrap material
along the guideline to determine how much, if any, the guideline must be
oset to get an accurate cut.
H
45
o
0
o
I
J
Making a pocket cut
1. Adjust the depth of cut as required per previous instructions
2. Adjust the bevel setting to 0°.
3. Raise the lower blade guard lever (9) to expose the saw blade and rmly
rest the front of the base at against the work piece with the rear handle
raised so the blade does not touch the work piece (Fig. K).
4. With the blade just clearing the work piece, start the motor by depressing
lock o button (13) and squeezing the on/o trigger (12).
5. Always let the blade reach full speed (approximately 2 seconds) before
you begin to cut into the work piece.
6. Slowly lower the circular saw into the work piece, using the front of the
base resting on the work piece as a hinge point.
WARNING! As soon as the blade starts cutting the material,
release the lower blade guard lever (9).
7. Once the base plate is at against the work piece, proceed cutting in a
forward direction to the end of the cut.
8. After completing your cut, release the on/o trigger (12) and allow the
blade to come to a complete stop.
Do not remove the circular saw from the work piece while the blade is
moving.