19
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
(toll free)
1200W Circular Saw
MODEL No.: PSC1856.A • 02/2021 • 704518
Recycle unwanted materials instead of disposing of them as waste. All
tools, hoses and packaging should be sorted, taken to the local recycling
centre and disposed of in an environmentally safe way.
Environmental Protection
Carbon brushes
When the carbon brushes wear out, the saw will spark and/or stop.
Discontinue use as soon as this happens. They should be replaced prior to
recommencing use of the saw. Carbon brushes are a wearing component
of the saw, and are not covered under warranty. Continuing to use the saw
when carbon brushes need to be replaced may cause permanent damage to
the saw. Carbon brushes will wear out after many uses but when the carbon
brushes need to be replaced, take the saw to a service agent for a quick and
low cost replacement. Always replace both carbon brushes at the same time.
General maintenance
Your saw requires no additional lubrication or maintenance. There are no user
serviceable parts in your power tool. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean. Keep all working
controls free of dust. Occasionally you may see sparks through the ventilation
slots. This is normal and will not damage your power tool.
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualied persons in order to avoid a hazard.
To Next Page
Loading...
