ALDI FERREX GSR2800 - Powering Shredder On and Off; Safe Use of the Pusher

Switching the device ON and OFF
NOTE!
Risk of damage!
- Avoid sudden changes of direction!
- Allow the device to come to a complete stop before switching
it on again!
Through poor conditions of the electrical MAINS, short voltage drops can
appear when starting the EQUIPMENT. This can influence other
equipment (eg. flickering of a lamp). If the MAINS-IMPENDANCE Zmax is
less than 0,355 OHM, such disturbances are not expected. (In case of
need, you may contact your local supply authority for further
information).
Switching on the device
The device can only be switched on when the standby LED
13
is lit red
(see section "Operating panel").
Operating mode forward:
1. Set the function selection switch
9
to forward.
2. Press the ON switch
10
.
The device is operating in forward mode.
Operating mode reverse:
1. Set the function selection switch
9
to reverse.
2. Press and hold the ON switch
10
.
Do not let the device run in reverse mode longer than necessary.
The device is operating in reverse mode.
Switching off the device
1. Press the OFF switch
11
.
2. Set the function selection switch
9
to the middle position.
The device is switched off!
Using the pusher
Use the pusher
14
if the material you want to shred is not automatically pulled in.
1. Insert the pusher into the hopper
8
.
Operation
19