Removing stuck material
CAUTION!
Risk of injury!
The knife drum rotating in the device can lead to injuries.
- If the feed chute or the discharge chute of the device gets
clogged, switch off the motor and pull the power plug from
the socket before you remove the stuck material.
- Never reach into the device with your hands to remove stuck
material, even if the device is stopped.
NOTE!
Risk of damage!
Pressing the function selection switch when the motor is running
may damage the device.
- Switch the function selection switch only when the device is
switched off.
Automated removal
1. Switch off the device (see section "Switching off the device").
2. If the overload protection has been triggered, reset it (see section "Resetting the
overload protection").
3. Switch the device into reverse mode (see section "Switching on the device").
Jammed material will be transported backwards.
4. Release the ON switch
.
The jammed material is removed or it must be removed manually (see section
"Manual removal").
Manual removal
When removing and installing components, refer to the overview or the
illustration on the cutter cover
.
1. Switch off the device (see section "Switching off the device").
2. Disconnect the device from the power supply.
Working with the shredder
23
To Next Page
Loading...
