ALDI FERREX GSR2800 - Emptying the Collection Container

2. Using the pusher, lightly push the material against the cutting drum
24
.
Emptying the collection container
Empty the collection container when it is about 3/4 full.
1. Switch off the device (see section "Switching the device ON and OFF").
2. Set the safety switch
4
to OFF (down).
3. Pull the collection container
17
out of the base frame
16
.
4. Empty the collection container.
Use the broom
31
to clean remaining material (wood chips and the like) from
the top rim of the collection container and the safety switch.
5. Insert the collection container into the device (see section "Inserting the
collection container").
The collection container is empty.
Operation
20