ALDI FERREX GSR2800 - Troubleshooting Common Issues; Standby LED Not Lit; Shredder Not Shredding; Long Shredded Material Output

Troubleshooting
Fault Possible cause Troubleshooting
Standby LED
13
not lit
red.
Power supply
disconnected
Check the power supply,
the socket and the cable
for damage and function.
Have any damage
repaired by a qualified
service technician.
Safety switch
4
on the
collection container
17
is
set to OFF position (down)
Set the safety switch
4
to the ON position (up).
Overload protection has
been triggered
Reset the overload
protection (see section
"Resetting overload
protection").
Device does not shred
Cutting drum
24
is
rotating the wrong way
Switch the device into
forward mode (see
section "Switching on the
device").
The material you want to
shred is too soft
Put in wood or shred dried
twigs.
Cutting drum
24
is
blocked
Remove the blockage (see
section "Removing stuck
material").
Shredded material is
discharged in long,
continuous pieces
Pressure plate
25
is not
adjusted correctly
Adjust the pressure plate
(see section "Adjusting
the pressure plate").
Troubleshooting
29