3. Use the Allen wrench
to remove the four screws
of the cutter cover
.
4. Pull off the cutter cover.
5. Carefully remove caked-on material from the cutting drum
and the pressure
plate
.
6. Pull out the cutting drum.
If necessary, use a flat-top screw driver
to lever it out.
7. Pull out the pressure plate to the front.
If necessary, use a flat-top screw driver
to lever it out.
8. Remove all shredded material from the device.
9. Insert the pressure plate.
10.Insert the cutting drum.
The groove in the cutting drum must be pushed precisely onto the feather key of
the drive shaft.
11. Insert the cutter cover.
12.Use the Allen wrench to attach the cutter cover with the four screws
.
The stuck material is removed.
Cleaning, maintenance and storage
WARNING!
Risk of electric shock!
Liquid entering the device can cause an electric shock.
- Do not hose the device down with water.
- It is essential to prevent water and other liquids from entering
the device.
WARNING!
Risk of injury!
After the motor has been switched off, the cutting drum
continues running for some time and can cause serious injuries.
- Make sure that the switch is set to OFF and the power plug has
been unplugged from the socket.
Working with the shredder
24
To Next Page
Loading...
