210cc 4 stroke Petrol High Pressure Washer
AFTER SALES SUPPORT
(toll free) MODEL No.: SHW196 • 06/2019 9885
e-mail: info.aldi@positecgroup.com
AUS
25
1300 889 028
AUS
NOTE:
• We recommend using SAE 10W-30 4 stroke engine oil. Use
of other types of oil can shorten the engine’s service life and
may cause damage to the engine. Wipe away any spilt oil.
• Engine oil should be changed after the first 5 hours of use.
After that, change the oil every 50 hours of use.
Adding fuel (see fig. L1, L2 )
WARNING: Make sure there is enough fuel in the fuel tank
(17) before operating. This is a 4-stroke engine and does
not require a fuel/oil mixture. There is a separate reservoir for
fuel and a separate reservoir for 4 stroke engine oil.
WARNING: Fuel is highly inflammable and extreme
precaution must be taken when handling or working with
it. Keep out of reach of children.
WARNING: Do not add too much fuel to exceed the
nominal volume of the fuel tank (17).
NOTE: During operation and transportation, fuel may leak out a
little. This is normal.
NOTE: Use fresh unleaded fuel. Do NOT use ethanol based fuels.
1) If it is necessary to add fuel, first make sure the engine is switched
OFF, not operating, and the engine has fully cooled before adding
fuel. Clean the area around the fuel tank cap (18), then remove the
fuel tank cap (18) by turning it anti-clockwise.
2) Use clean fresh unleaded fuel with a minimum of 87 octane. DO
NOT use old fuel.DO NOT mix oil with fuel.
3) Refuel carefully to avoid overfilling or spilling. Do not fill the fuel
tank further than the top rim of the fuel tank filter.
4) Clean up any overflow or splash of fuel before starting the engine.
5) Tighten the tank cap (18) securely after filling by rotating in an anti-
clockwise direction.
NOTE:
● When refueling, make sure the fuel filter (29) is in place and
To Next Page
Loading...
Need help?
General
