210cc 4 stroke Petrol High Pressure Washer
AFTER SALES SUPPORT
(toll free)MODEL No.: SHW196 • 06/2019 9885
e-mail: info.aldi@positecgroup.com
AUS
42
1300 889 028
AUS
STORAGE
1. Shut OFF engine, turn off water supply. Squeeze the trigger switch
to relieve trapped pressure, lock the trigger switch of spray gun,
place the gun on storage for spray gun (19). Let the engine cool.
2. Disconnect hose from spray gun and water outlet on pump. Drain
water from hose, gun, and nozzle. Use a rag to wipe off the hose.
3. Place the spray gun and nozzles in appropriate storage. Coil high
pressure hose on hose reel.
4. Empty pump of all pumped liquids by pulling the start handle about
six times. This should remove most liquid in pump.
5. Store the washer in a clean, dry area. Store machine and accessories
in a room which does not reach freezing temperatures.
6. If you will not be using this product for a long period of time,
dismantle all the accessories.
NOTE:
● Do NOT allow high pressure hose to become kinked.
● DO NOT store near furnace or other sources of heat as it may
dry out the pump seals.
To Next Page
Loading...
Need help?
General
