36
Operation:
When the baby is sleeping quietly without making any
noise, the parent unit disables the display and sound.
As soon as the parent unit starts to receive sounds, and
the loudness of this sound exceeds the set sensitivity level,
the display and sound are enabled again.
BrieypresstheVIEW button to watch and listen in
between.Thedisplayandsoundswitchoagainafter
approximately 60 seconds.
Temperature alert and notation (°C or °F):
The upper part of the screen shows the temperature
measured by the baby unit in the baby room. You may
assign an alert to this display that warns you in case the
temperature becomes too low or too high.
Attention, separate steps must be followed for setting the
upper and lower limit and for enabling the alert:
Lower limit setup:
1. Press the MENU button and use the or button to
scroll to the option.
2. Press the SELECT button and use the or button
to select the option.
3. Press the SELECT button and use the or button
to set the desired minimum temperature (the black
arrow indicates the current lower limit setting)
4. Press the SELECT button to save your setting and
press the VIEW button to close the menu.
Upper limit setup:
1. Press the MENU button and use the or button to
scroll to the option.
2. Press the SELECT button and use the or button
to select the option.
3. Press the SELECT button and use the or button
to set the desired maximum temperature (the black
arrow indicates the current upper limit setting)
4. Press the SELECT button to save your setting and
press the VIEW button to close the menu.
To Next Page
Loading...
Need help?
General
