22
T
o use BFD player as a standalone drum module:
1. Use a USB cable (sold separately) to connect to the USB port on the module's
rear panel to an available USB port on your computer.
2. Install BFD Player and any associated Expansion Packs.
3. Open your BFD Player software.
4. Select the C
og icon (Settings) in the bottom left corner of BFD Player.
5. In the A
udio section, select your Sample Rate, Buer Size, and Output. Be sure
that your headphones are connected to whatever audio source you have
selected, such as your laptop's headphone output or audio interface's output.
Important: Audio from BFD Player will not be sent out of the Nitro Max's
headphone output.
6. In M
IDI Input Device, select "Alesis Nitro Max".
7. Close the settings window.
8. In the left side of the BFD Player's window, select the expansion pack kit you
would like to use.
9. Play your Nitro Max Kit and enjoy!
To Next Page
Loading...