alues/Settings
Mode
This setting determines what, if any, control function will
be performed when the pad is triggered.
Off: Triggering the pad does not perform a
control function.
Next Kit: Triggering the pad loads the next kit.
Previous Kit: Triggering the pad loads the
previous kit.
Click On/Off: Triggering the pad turns the click
on or off.
Tap Tempo: Triggering the pad acts as a tap
tempo.
Panic: Triggering the pad sends a MIDI Panic
message, stopping all notes from sounding.
Looper Rec: Triggering the pad controls the
Looper record state. Note that Loop View must
be active before triggering.
The first trigger will set the Looper from Arm to
Record to Start Record. The next trigger will
set the Looper to start recording, beginning
with a countdown. If triggered again before the
number of measures set have passed, the
Looper will stop recording and enter playback
on the next downbeat. Once playback is
initiated, trigger the pad to start or stop
overdub recording.
Looper Play/Stop: Triggering the pad starts or
stops playback of the loop. Note that a Loop
View must be active and a loop must be
recorded before triggering.
Kit FX 1 On/Off: Triggering the pad turns Kit
FX1 on or off.
Kit FX2 On/Off: Triggering the pad turns Kit
FX2 on or off.
Kit FX 3 On/Off: Triggering the pad turns Kit
FX3 on or off.
MST FX On/Off: Triggering the pad turns the
Master Effect on or off.
Sound
This setting determines whether the pad sound will be
triggered.
On, Off
Output
Press the F3–Output button to edit the pad output settings.
Parameter Description
udio Output
This setting determines the audio output routing for
the pad, trigger or footswitch.
Main+Phone, FX1–3, Aux+Phone, Phone
Only
Kit FX Level
This setting determines the output level of effects
applied to the kit.
000–127
MIDI Note Output
This setting determines the MIDI note that is sent
when a pad, trigger or footswitch is pressed.
000–127
To Next Page
Loading...
