20
Utility Menu
The Utility menu is where you can edit various parameters for Strike Multipad's hardware and firmware functionality.
MIDI
Press the F1–MIDI button to open the MIDI menu, where you can adjust the MIDI settings for Strike Multipad.
Parameter Description
alues/Settings
Global MIDI
Channel
This setting determines the MIDI channel that Strike Multipad sends
messages on.
1–16
MIDI Sync
This setting determines whether Strike Multipad receives external MIDI
Clock signals. When On, MIDI Clock signal will override the Global
Tempo.
On, Off
Local Control
This setting determines whether Strike Multipad triggers its internal
sounds.
On, Off
MIDI Thru
This setting determines whether MIDI received from the MIDI Input will
be sent back out through the MIDI Output.
On, Off
Program Change
Switch
This setting determines whether Strike Multipad will change kits when
receiving program change messages. When On, Program Change
Inc/Dec messages will act as the Kit +/- buttons, and Program Change
Number messages will match the Kit Number as shown on the display
(Bank 0 = Presets, Bank 1 = User).
On, Off
5-Pin MIDI to USB
This setting determines whether MIDI received by the 5-pin MIDI DIN
input is passed to USB.
On, Off
Audio
Press the F2–Audio button to open the Audio menu, where you can adjust the audio settings for Strike Multipad.
Parameter Description
alues/Settings
Rec In Vol
This setting determines the digital level for Record In, separate from the
analog gain.
0–100
USB In Vol
This setting determines the level of the USB audio input.
0–100
USB Out Vol
This setting determines the level of the USB audio output.
0–100
Rec In Output
This setting determines the audio routing of the analog Record In signal.
Main,
ux, Phone
System Gain
This setting determines the additional digital gain for the Main outputs.
0dB, 6dB, 12dB
FX1 Output
This setting determines the audio output routing for FX1.
Main+Phone,
To Next Page
Loading...
