7 Operating instructions
2. Bowl wall
7.3 Before start
1. Make sure that the pump is fully primed.
Connect the inlet tube to the pump with the
suction pipe and pour oil into the pump as
illustrated.
2. Connect the hoses as described in chapter 4
Description of main parts. Make sure that the
hoses to the pump are correctly connected.
G0978741
3. The separator is set up as clar ifier when
delivered. In case purifier m ode is needed,
please conver t the bowl as described in chapter
5.4 Changing operation mode on page 22
4. Never start the separator with sludge
remaining in the bowl.
!
W
A
R
N
I
N
G
Disintegration hazard
Unevenly spaced sludge cak
ewillresultinheavy
vibration with possible
damage to the separator.
37
To Next Page
Loading...
