5 Installation
Step 4
1. Ensure that the unit is correctly mounted by pressing down on
top of the ThinkTop Basic AS-Interface.
2. Tighten the two Allen screws carefully (1.50 Nm).
3. Turn the actuator to have LEDs in a front view.
Step 5
Fit the ø6 mm (1/4”) air tubes to ThinkTop Basic AS-Interface .
(see drawing
“Air connections” page 13).
Step 6
Fit the air tubes to the actuator
(see drawing “Air connections” page 13).
TD 800-131
Step 7
Untighten the four screws and pull off cover of ThinkTop Basic
AS-Interface.
TD 800-158
1
2
To Next Page
Loading...
