Alfa Laval ThinkTop Basic User Manual

2 Safety
Unsafe practices and other important information are emphasized in this manual.
Warnings are emphasized by means of special signs. All warnings in the manual are summarized on this page.
Pay special attention to the instructions below so that severe personal injury or damage to the top unit are avoided.
2.1 Important information
Always read the manual before using the top unit!
WARNING
Indicates that special procedures must be followed to avoid serious personal injury.
CAUTION
Indicates that special procedures must be followed to avoid damage to the ThinkTop Basic AS-Interface.
NOTE
Indicates important information to simplify or clarify procedures.
2.2 Warning signs
General warning:
Dangerous electrical voltage:
Caustic agents:
2.3 Safety precautions
Installation:
Always read the technical data thoroughly (See chapter 6 Setup diagram)
Never install the ThinkTop Basic AS-Interface before valve or relay is in a safe position
If welding close to the ThinkTop Basic AS-Interface: Always earth close to the welding area
Disconnect the ThinkTop Basic AS-Interface.
Always have the ThinkTop Basic AS-Interface electrically connected by authorized personnel
Maintenance:
Always read the technical data thoroughly (See chapter 6 Setup diagram)
Always fit the seals between valve and ThinkTop Basic AS-Interface correctly
Never install the ThinkTop Basic AS-Interface before valve or relay is in a safe position
Never service the ThinkTop Basic AS-Interface with valve/actuator under pressure
Never clean the ThinkTop Basic AS-Interface with high pressure cleaning equipment
Never use cleaning agents when cleaning the ThinkTop Basic AS-Interface. Check with cleaning agent supplier.
5

Alfa Laval ThinkTop Basic Specifications

General

Brand	Alfa Laval
Model	ThinkTop Basic
Category	Controller
Language	English