5 Installation
Step 8
1. Install cable (if not present) through the cable gland.
2. Connect the ThinkTop Basic AS-Interface electrically
(see page 5.3 Electrical connection, internal).
TD 800-157
Step 9
Make sure the cable gland is completely tightened.
TD 800-159
Step 10
Set up the ThinkTop Basic AS-Interface (see chapter 6 Setup diagram).
NOTE!
The unit can be set up by internal push bottons on sensor board. To energize the valve, use manual hold override on the
solenoids valve or be in radio contact with the control room.
5.2 Air connections
TD 800-184_2
A
B
C
D
E
F
G
H
I
A. Air out 1A
B. Air exhaust
C. Air out 1B (5/2 port solenoid valve only)
D. Solenoid 3/2 or 5/2
E. Solenoid valve (3/2) only
F. Ai r i n
G. Air out 3
H. Air out 2
I. Manual hold override
13
To Next Page
Loading...
