5 Installation
5.1 Installation on air actuators
Step 1
Always read the technical data thoroughly.
Always have the ThinkTop Basic AS-Interface electrically
connected by authorised personnel.
Never install the ThinkTop Basic AS-Interface before valve or relay
is in a safe position.
Step 2
1. Fit the air fittings on actuator if not mounted.
2. Fit the indication pin and tighten carefully
with a spanner (A).
Note:
The threaded plate (B) is only used for the SRC and SMP valve
types.
(A)
(B)
TD 800-011_2
Step 3
1. Place the ThinkTop Basic AS-Interface on top of the actuator.
2. Make sure X-ring is mounted.
85
11
To Next Page
Loading...
