7 Maintenance
Study the instructions carefully.
Handle scrap correctly.
Always keep spare X-rings in stock.
Step 5
To remove the sensor unit untighten screw and pull out
the sensor unit.
TD 805-004
7.2 Assembling the ThinkTop
®
Step 1
Place sensor unit in base and tighten screw (torque: 1 Nm).
TD 805-005
Step 2
1. Replace the black X-ring.
2. Assemble base with adapter by turning adapter slightly
anticlockwise and tighten the four screws (1.9 Nm).
CAUTION!
DoNOTtwisttheX-ringinthegroove!
The X-ring is not square; The highest (h) part
must be placed as fig.
TD 800-233
Note:
Turn banjo
connection!
17
To Next Page
Loading...
