Alfa Laval ThinkTop Digital 8 User Manual

6
1.1 Important information
1.2 Warning signs
1.3 Safety precautions
1. Safety
Unsafe practices and other important information are emphasized in this manual.
Warnings are emphasized by means of special signs.
All warnings in the manual are summarized on this page.
Pay special attention to the instructions below so that severe personal injury or damage to the top unit are avoided.
Always read the manual before using the top unit!
WARNING!
Indicates that special procedures must be followed to avoid severe personal injury.
CAUTION!
Indicates that special procedures must be followed to avoid damage to the ThinkTop
®
.
NOTE!
Indicates important information to simplify or clarify practices.
Installation
- Always observe the technical specifications (see chapter 3).
- Never install the ThinkTop
®
before valve or relay is in a safe position.
- If welding close to the ThinkTop
®
: Always earth close to the welding area.
- Disconnect the ThinkTop
®
.
- Always have the ThinkTop
®
electrically connected by authorized personnel.
Maintenance
- Always read the technical specifications thoroughly (see chapter 3).
--
--
- Always fit the seals between valve and ThinkTop
®
correctly.
- Never service the ThinkTop
®
before valve or relay is in a safe position.
- Never service the ThinkTop
®
with valve/actuator under pressure.
- Never clean the ThinkTop
®
with high pressure cleaning equipment.
- Never use cleaning agents when cleaning the ThinkTop
®
. Check with cleaning agent supplier.
General warning:
Dangerous electrical voltage:
Caustic agents:

Alfa Laval ThinkTop Digital 8 Specifications

General

Brand	Alfa Laval
Model	ThinkTop Digital 8
Category	Control Unit
Language	English